What the..... inverter installation made easy

The first step in doing a DIY inverter install on your boat is to find a 12 VDC source. This is usually a big red wire. A battery switch is a good place to find one. Don't worry at all about it shorting against the common leg of the switch. That thin plastic coating on the handles of the clip is there to insulate them. It looks fine, and is color coordinated. The clip has the appearance of permanence, requires no expensive special ;tools to install it, and has the panache I like to see in a marine electrical installation. You won't need any of those dangerous and unsightly restraints like tie wraps either.

Too much tech, but not enough lifetime.

I'm the oldest of three male urchins. Because I was the oldest, I got the more important jobs in the household. At about 12 years of age, I was promoted, and the next oldest sibling got my old job of taking the pipe wench outside, and using it to turn the antenna pole until the Chief, (spelled Dad) yelled that's good, no no back a bit, stop." It was 1964. There were three TV stations that operated until about midnight, and we watched it on a black and white TV. This was good because I had now graduated to the job of TV repairman PFC Bishop.

This job consisted of quietly watching the activities when the TV was not feeling well. The scenario was always the same. The TV lived in a custom built niche, and much like the Virgin Mary, the set was metaphorically worshiped nightly. When the TV broke, the Chief would extract it, and set it on the dining room table. Screws were removed, the back came off, and the plug was detached from the back, and plugged back into the set. The lights would be turned down, and the set was turned on. All available eyes would look at the tubes to see who would be the first to spot the tube that was not glowing. "Aha", would declare the Chief, that's the problem. The set would be unplugged, the tube extracted and put into my hands.